The** radioactive decay law** states that the probability per unit time that a nucleus will decay is a constant, independent of time. This constant is called the **decay constant** and is denoted by λ, “lambda”. This constant probability may vary greatly between different types of nuclei, leading to the many different observed decay rates. The radioactive decay of certain number of atoms (mass) is exponential in time.

**Radioactive decay law: N = N.e ^{-λt}**

The rate of nuclear decay is also measured in terms of **half-lives**. The half-life is the amount of time it takes for a given isotope to lose half of its radioactivity. If a radioisotope has a half-life of 14 days, half of its atoms will have decayed within 14 days. In 14 more days, half of that remaining half will decay, and so on. Half lives range from **millionths of a second for highly radioactive **fission products to **billions of years for long-lived materials** (such as naturally occurring uranium). **Notice that** short half lives go with large decay constants. Radioactive material with a short half life is much more radioactive (at the time of production) but will obviously lose its radioactivity rapidly. No matter how long or short the half life is, after seven half lives have passed, there is less than 1 percent of the initial activity remaining.

The radioactive decay law can be derived also for activity calculations or mass of radioactive material calculations:

**(Number of nuclei) N = N.e ^{-λt} (Activity) A = A.e^{-λt} (Mass) m = m.e^{-λt}**

, where N (number of particles) is the total number of particles in the sample, A (total activity) is the number of decays per unit time of a radioactive sample, m is the mass of remaining radioactive material.

## Decay Constant and Half-Life

In calculations of radioactivity one of two parameters (**decay constant** or **half-life**), which characterize the rate of decay, must be known. There is a relation between the half-life (t_{1/2}) and the decay constant λ. The relationship can be derived from decay law by setting N = ½ N_{o}. This gives:

where *ln 2 *(the natural log of 2) equals 0.693. If the decay constant (λ) is given, it is easy to calculate the half-life, and vice-versa.

## Decay Constant and Radioactivity

The relationship between **half-life** and the amount of a radionuclide required to give an activity of one curie is shown in the figure. This amount of material can be calculated using **λ**, which is the **decay constant** of certain nuclide:

The following figure illustrates the amount of material necessary for **1 curie** of radioactivity. It is obvious, that the longer the half-life, the greater the quantity of radionuclide needed to produce the same activity. Of course, the longer lived substance will remain radioactive for a much longer time. As can be seen, the amount of material necessary for 1 curie of radioactivity can vary from an amount too small to be seen (0.00088 gram of cobalt-60), through 1 gram of radium-226, to almost three tons of uranium-238.

## Example – Calculation of Radioactivity

A sample of material contains 1 mikrogram of iodine-131. Note that, iodine-131 plays a major role as a radioactive isotope present in nuclear fission products, and it a major contributor to the health hazards when released into the atmosphere during an accident. Iodine-131 has a half-life of 8.02 days.

**Calculate:**

- The number of iodine-131 atoms initially present.
- The activity of the iodine-131 in curies.
- The number of iodine-131 atoms that will remain in 50 days.
- The time it will take for the activity to reach 0.1 mCi.

**Solution:**

- The number of atoms of iodine-131 can be determined using isotopic mass as below.

**N**_{I-131}** = m**_{I-131}** . N**_{A}** / M**_{I-131}

**N**_{I-131 }**= (1 μg) x (6.02×10**^{23}** nuclei/mol) / (130.91 g/mol)**

**N**_{I-131}** = 4.6 x 10**^{15}** nuclei**

- The activity of the iodine-131 in curies can be determined using its
**decay constant**:

The iodine-131 has half-live of 8.02 days (692928 sec) and therefore its decay constant is:

Using this value for the decay constant we can determine the activity of the sample:

3) and 4) The number of iodine-131 atoms that will remain in 50 days (N_{50d}) and the time it will take for the activity to reach 0.1 mCi can be calculated using the decay law:

As can be seen, after 50 days the number of iodine-131 atoms and thus the activity will be about 75 times lower. After 82 days the activity will be approximately 1200 times lower. Therefore, the time of ten half-lives (factor 2^{10} = 1024) is widely used to define residual activity.

We hope, this article, **Decay Constant**, helps you. If so, **give us a like** in the sidebar. Main purpose of this website is to help the public to learn some interesting and important information about materials and their properties.